Rat Rod Nation - A place for motorheads

Rat Rod Nation General Area => Rat Rod Nation Intro's => Topic started by: ratrodaddict on October 17, 2016, 07:51:24 PM

Title: Just getting started
Post by: ratrodaddict on October 17, 2016, 07:51:24 PM

Hey Nation,

 Just getting the Rat Rod itch. I am 46 going on 47 and have wanted to get the ball rolling on a rod project. I am currently looking at picking up a '52
F-1 with a flathead and 3 speed on the tree. I am planning on a chop and channel job, no front sheet metal and just bed sides. I would like to use the flathead but would like an updated trans (top loader or auto with OD) not sure what trans swaps work for the flatty. Also looking for advise on frames. Have seen folks using s10 frames, ranger frames....any recommendations here? Air ride is a must. I look forward to chatting with everyone and hope to start this thing off soon.

G

Title: Re: Just getting started
Post by: lowboy on October 18, 2016, 06:35:42 AM

welcome to the nation from S Illinois I used a Ranger chassis on mine but I'm a Ford guy. Look around and ask any questions you may have. Look in Speedway catalog for adapter plates for tranny.

Title: Re: Just getting started
Post by: Blackwater on October 18, 2016, 08:02:54 AM

Welcome from Middle Tennessee! 

Check with TransDapt and Novak as well!!

Title: Re: Just getting started
Post by: dcacjc on October 18, 2016, 10:17:32 AM

Welcome from Texas!!

T5 make a tranny for a flatty

Title: Re: Just getting started
Post by: hotwheels on October 21, 2016, 08:31:48 AM

Welcome to the nation, it's great to meet ya. I like the S10 frames my self.