Rat Rod Nation - A place for motorheads
Rat Rod Nation builds => Rat Rod Frame/Suspension/Brake Q&A => Topic started by: sponge on February 06, 2021, 03:59:55 PM
-
I was talking to Blackwater about this on another post. I'm putting a straight axle on a scratch built rod. I have triangulated four bar for anti roll for and aft and side to side. Air bag on bottom rods to get my ride hight.(the Frame will be on the ground when parked)
This is what I have so far. Everything is just tacked to see if it's really going to work. I'm waiting for Mustang II rack to mount to the front of the axle. I am making friction shocks to come off the side of the frame at the front an go to the rear of the axle and connect with a link.
Any thoughts, ideas, suggestions?
-
Looks like the suspension part should work. i'm thinking you will want to add a sway/anti roll bar as your mounting points a all inboard of the frame.
I'm interested to see how you mount and use the steering rack.
-
I know it's been a while but I'm getting there. Everything just tacked but looks like it will work. As always any thoughts good or bad are appreciated.
Thanks Sponge
-
Looking good
-
It looks pretty solid from the pics. Be sure to cap the ends of your frame rails!! It will add a layer of strength to the area where your suspension is mounted at the outside.
-
Thanks guys.
I'm in the process of getting things solid. All will be closed up and more support brackets welded in. Too much is just enough!
-
Made any progress on this lately ???