IMG 20130303 140308
Inside the bed before all of the mounting angles are installed. The rear suspension takes up half of the room in the bed. Notice how the bed is cut out for the axle and the pan bar? March 4, 2013
 Views: 554
 Mar 05, 2013
|
IMG 20130303 134102
Seeing what the bed looks like in place and where to put the mounting tabs. March 4, 2013
Views: 605
Mar 05, 2013
|
IMG 20130303 134058
Getting a feel for where the bed should sit. March 4, 2013
Views: 599
Mar 05, 2013
|
IMG 20130303 125308
Building the bed. March 4, 2013
Views: 550
Mar 05, 2013
|
IMG 20130303 125258
Starting to make the bed. The bed was originally one side of a mid-50's era ford 1 1/2 ton truck. It measured right at 9 feet long. Now it is two sides that are 40" long. March 4, 2013
Views: 587
Mar 05, 2013
|
IMG 20130228 143041
Notice the 2" breather spacers used to clear the distributor with the scoop. Febuary 19, 2013
Views: 524
 Comments: 1
 Rating: 4.96
Mar 05, 2013
|
IMG 20130228 143010
We had to use 2" breather spacers to clear the distributor with the scoop. Febuary 19, 2013
Views: 499
Comments: 1
Rating: 4.96
Mar 05, 2013
|
IMG 20130228 142959
The new motor is in place now. We had to use 2" breather spacers to clear the distributor with the scoop. Febuary 19, 2013
Views: 548
Mar 05, 2013
|
IMG 20130215 204719
Myers pinstriping the tank for the 38 at the Tulsa Starbird show 2013. Febuary 16, 2013
Views: 523
Mar 05, 2013
|
IMG 20130215 204250
Ron Myers pinstriping the tank for the 38 at the Tulsa Starbird show 2013. Febuary 16, 2013
Views: 501
Mar 05, 2013
|
IMG 20130210 151522
Trying to cram the distributor in a tight spot. Febuary 10, 2013
Views: 536
Comments: 1
Rating: 4.96
Mar 05, 2013
|
IMG 20130209 113426
Febuary 9, 2013
Views: 524
Rating: 4.96
Mar 05, 2013
|
IMG 20130209 113416
Febuary 9, 2013
Views: 516
Mar 05, 2013
|
IMG 20130209 113409
Close up of the new motor going in the 38. Febuary 9, 2013
Views: 509
Mar 05, 2013
|
IMG 20130209 113404
new motor waiting to be put in the 38. Febuary 9, 2013
Views: 513
Mar 05, 2013
|
