AuthorTopic: Tooling Plastic  (Read 1864 times)

0 Members and 1 Guest are viewing this topic.

Offline lowboy

  • Global Moderator
  • Rat Rods or Nothing
  • *****
  • Posts: 4998
  • Vehicle: 1973 Volkswagen Beetle
  • Activity:
  • Referrals: 3
Tooling Plastic
« on: January 11, 2014, 09:08:58 PM »
Is there a good way to tool plastic i kinda melted/cut it to make a couple of spacers for the rear of the bug I used a wood hole cutter and my wood chop saw it is 1/2 in thick plastic was told its teflon but im not sure
life is a ride where you slide into heaven sideways on 4 flats blown motor saying Thank you God what a ride!!!!!