Rat Rod Nation builds > Rat Rod Transmission, Rear End Discussions

drive shaft

(1/2) > >>

just old:
I have to cut the drive shaft and shorten it . do you do your own or do you send it out and have it done ? had to move rear and by doing so now it has to be cut

Rust T Nuts:
I always have mine done by a shop that can also balance it,   I had a 54 Chevy that had a ford 9 inch rest and 350 tyranny,  I
Had a custom yoke shaft built for it. 

miraclepieco:
I have friends who do their own using a lathe and runout dial, etc but I just have 'em done by a shop. It's quick, reasonably priced and I don't have to worry about balance or runout.

lowboy:
somebody on here posted they had built one but don't remember who
found it http://www.ratrodnation.com/forum/share-a-link/how-to-shorten-a-driveshaft/msg22594/#msg22594

notw:
That was some good info not as intricate as I thought

Navigation

[0] Message Index

[#] Next page